TJ Track Bar Mount - Frame Side (2.5" - 3.5" Stretch)

  • $41.99
    Unit price per 

Only 2 left!

TJ/ TJU Track Bar Mount

 This heavy duty track bar mount will replace your factory mount and allow for a 2.5" - 3.5" stretch forward of the factory position. Perfect for use with our TJ 1 Ton Axle Swap for added clearance.

 
  • Designed to curve the factory frame and align the trackbar position
  • Locates off a factory frame hole for easy positioning
  • Track bar bracket can slide on frame plate forward or backward until you find the best location with your set up
  • 3 hole locations for finding the right steering/track bar geometry...1.3" in between each hole
  • If using the top two holes, you can cut off the bottom of the bracket for higher clearance
  • 1.75" Mounting width to fit our 7/8" x 3/4" rod ends with high misalignment spacers. (Will not work with a Factory Replacement Joint)
  • CNC laser cut and CNC bent from 1/4" steel for precision fit and heavy duty use


NOTE: This kit requires general welding and fabrication skills including welding to the cast center section. Welding should only be done by a competent welder. Artec Industries implies no guarantees or warranties and is not liable for improper installation.
*Some grinding and fitment may be required when installing this kit. Every axle varies slightly and some fabrication may be required.
Artec
TJ2001

⚠WARNING: This product can expose you to chemicals, which are known to the State of California to cause cancer and birth defects or other reproductive harm.  For more information go to www.P65Warnings.ca.gov.