DTF Equipment, Capabilities, and Labor Rates

Labor:

Standard wrenching, research, proposals, or part sourcing: $80 per hour + materials
Cutting or welding: $105 per hour + materials
Design or fabrication: $130 per hour + materials
Axle gearing:

Set prices will be based on below criteria and are to be paid up front.

Prices are subject to change during the install due to issues that could be run into. This will be communicated before continuing with the install.

All hard parts will be paid for up front.

Base Prices By Axle
GM Corporate (AAM) 14 bolt 10.5"	$550
Dana 60	$600
Dana 70	$600
Dana Super 70 Rear	$575
Dana 80	$600
GM AAM 11.5"	$575
Dana 30	$600
Dana 35	$600
Dana 44	$600
Sterling 10.25	$600
Sterling 10.5	$600
GM 10 bolt	$600
AMC20	$600
Ford 9"	$550
Ford 8.8	$600
Toyota 8"	$575
Toyota 8.4"	$575
Up Charges Per Axle
Dirty axle externally (grease, oil, flaking rust, etc)	$100.00
Axle not disassembled with axle shafts removed (stock pinion and carrier need to be left in the housing!!!)	$200.00
Axle missing pinion (makes setting pinion depth more of a PITA!!!)	$200.00
Axle not drained of gear oil	$50.00
Axle rusty/dirty/debris in the housing and requiring cleaning/blasting	$100.00
Axle in the vehicle	$200.00
Lunch box locker or mini spool install while gearing	$50.00
Full case locker while gearing	$50.00
Welding differential	$100.00
Axle reassembly (shafts, wheel bearings, hubs, brakes, etc.)	$80.00/hour
ARB locker installation (each)	$100.00
Eaton E-locker installation (each)	$50

Welding:

Cutting:

Cleaning: