Dana 30 / Dana 44 Front Lower Control Arm Brackets Jeep XJ / TJ / TJU / ZJ / MJ
2.625" mounting width fits common sized Cartridge Joints (Johnny, Flex, Ballistic, etc) and factory control arm bushings.
Skid plate of bottom of bracket wraps around joint protecting it from direct impact and decreases premature wear on the joint. This leads to longer life and less replacements. Skid plate design does not restrict movement of joint.
Bracket wraps around axle tube more than factory for additional weld surface area, which significantly reduces the chance the bracket can rip off.
Made from 1/4" thick boxed steel plate for strength and impact resistance.
Grease fitting access on top to allow easy maintenance of your most abused joint.
NOTE: DESIGNED FOR USE WITH ADJUSTABLE CONTROL ARMS SINCE NO CAM SLOT IS USED. This bracket requires welding to the axle and removal of the factory bracket. Welding should be done by a competent welder and Artec Industries is not liable for incorrect installation or improper welding. "Horseshoe" pieces also require welding to the main bracket and the main bracket is laser etched to show where to weld.
- Artec Industries
- Artec Industries TJ3012
WARNING: This product can expose you to chemicals, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.