39/64" Drill Bit
- 39/64" diameter drill bit (.609")
- 118° drill point
- Requires a 1/2" or larger drill chuck
- Flats on the shank (helps prevent spinning and wobbling)
- Used to drill out for wheel lug studs
- Must be used in a low RPM drill press. Large drills like this need lower surface footage for cutting and a rigid setup to prevent walking or oversized holes
- Made in the U.S.A.!!!
- (1) drill
- Custom axle builds where different lug studs are being used
- Down To Fab
- Down To Fab DTF000010
- None against wear or breakage during use.
WARNING: This product can expose you to chemicals, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.